[1]Download Fedora 20 ( released on 18 December, 2013 ) from the following site.

? http://download.fedoraproject.org/pub/fedora/linux/releases/20/Fedora/x86_64/iso/ It's OK to download 64 bit version commonly. But if your computer is very old and not supported 64 bit computing, download the 32 bit version below. ? http://download.fedoraproject.org/pub/fedora/linux/releases/20/Fedora/i386/iso/ * The example on this site uses 64 bit version.

[1]Insert the Fedora install disk and start Computer. Then, Following screen is displayed, Push Enter key to proceed.

[2]Select the language you'd like to use during the installation.

[3]This is the default screen for some basic configuration. First, set timezone, click DATE&TIME icon.

[4]Click a point on the map you'd like to set your timezone and push "Done" button which is on the upper left.

[5]Return to the default screen of [3], next set keyboard settings.Click KEYBOARD icon to go the screen like below and click "+" button on under-left.

[6]Select your keyboard type and click "Add" button.

[7]After adding keyboard layout, send up your keyboard on the top for 1st priority like follows and click "Done" button which is upper left to finish.

[8]Back to the default screen of [3]. Set softwares to install. Click SOFTWARE SELECTION icon and select "Minimal Install" like follows and click "Done" button to finish. It's unnecessarry to install many packages at first.

[9]Back to the default screen of [3]. Click "INSTALLATION DESTINATION" and select installation disk. Click the disk icon you'd like to install Fedora and next, click "Done" button on upper left to proceed.

[10]On this example, select "Automatically configure ***" and proceed to next. But if you'd like to edit the partition layouts manually, select "I want to review ***" and proceed to next.

[11]If it's OK all, click "Begin Installation" and proceed to next.

[12]Installation starts and required to set root password and to create a common user. Click the each icon and move to configuration.

[13]On the root password settings, input any password you like and click "Done" button to finish as follows.

[14]On the common user settings, input any user name and password you like and click "Done" button to finish as follows.

[15]Click "Finish Configuration" in the lower right.

[16]After finishing installation, click "Reboot" button.

[17]After rebooting, login prompt is shown like follows. login with root user and password you set during installation. Installing Fedora 20 completes if you can login normally.